Ensure the pin is up to inflate. If the pin is down, push in then twist counter-clockwise to release. Attach the air hose to the inflate side of the pump. Insert the air hose and twist clockwise to lock it in place. Inflate to around 7-8psi and no higher than 10psi.
Step 2 of 5
Pro Chiller Connections
Pro Chiller setups only. Slide the gasket over the male threads of the shutoff valve. Check for a gasket already inserted into the opposite side. Thread the F50 camlock connection into the female side of the shutoff valve. Repeat for the other shutoff valve. Thread each assembly into the inlet and outlet of the tub.
Step 3 of 5
Pro Chiller Fittings
Slide the gasket onto the threaded section, making sure it seats properly to create a secure seal. Fasten type A quick connect fittings to both the inlet and outlet of the chiller.
Step 4 of 5
Standard Chiller Connections
For the standard chiller, apply plumbers tape to the two provided F50 fittings. Thread one into the inlet and outlet of the tub. The chiller comes with fittings pre applied, however if you are adding filtration complete that tutorial prior to finishing the tub setup.
Step 5 of 5
Connect Hoses
Connect the two hoses between the chiller and tub. The top connection connects to the top connection and bottom to bottom.
